Directions for Winding Rolls
When Paper Leads on Over the Roll "A" and Operator is Facing Roll
 

1. Right chuck (right hand thread) is attached to shaft b on operator's left hand side.
2. Left chuck (left hand thread) is attached to shaft B on operator's right hand side.
3. With paper roll or core in place tighten:

  1. Expansion nut D1 in direction of arrow
2. Clamping bolt C1
3. Expansion nut D2 in direction of the arrow
4. Clamping bolt C2
4. When removing chucks, reverse the operation
Note: Nut D1 and D2 should move closer to clamping bolts C1 and C3 when the above directions are followed
 
 
When Paper Leads on under the Roll "A" and Operator is  Facing Roll, Reverse the Chucks as in Illustration Above..
IMPORTANT! Keep moving parts of chuck greased
 
Directions for Unwinding Rolls
When Paper is Drawn Over Top Roll "A" and Operator is Facing Roll
 
1. Right chuck (right hand thread) is attached to shaft B on operator's left hand side.
2. Left chuck (left hand thread) is attached to shaft B on operator's right hand side.
3. With paper roll or core in place tighten:
  1. Expansion nut D1 in direction of the arrow
2. Clamping bolt C1
3. Expansion nut D2 in direction of the arrow
4. Clamping bolt C2
It is absolutely essential at all times to tighten expansion nut in the direction the paper is unwinding.
Nut D1 and D2 should move closer to clamping bolt C1 and C2 when above directions are followed
 
When Paper Is Drawn from Bottom of Roll "A" and Operator Is Facing the Roll, Reverse the Chucks as in Illustration Above
IMPORTANT! Keep moving parts of the Chuck greased
Return to Prior Page